How do I install the Brush?

1. Stow the steering handle (see "Steering Handle").
   
   

   
   
   
   

2. Hold the lift handle with one hand, and hold the handle down with another hand.

   - Please operate with two people.
   
   
   
   
   

3. Gently lay the machine down so that the dustbin faces upward.

   The rubber pad will support and stabilize the machine.

   - Please be cautious so the handle does not stick out of the machine.

   - Take care not to let the machine fall forcefully or to turn.

   - Concrete or other hard surfaces will scratch the machine; place the machine on carpeting or other soft and flat surface.

   
   Please set the secondary battery power button On (see "Secondary Battery Power Button"). Also, remove the protective film on the cliff sensors.
   
   

4. Check the marks on the left and right ends of the new brush
   
   

   The mark on the left	The mark on the right

   - When the machine is laid down with the front side facing upwards, you will see the sockets of the brush case, both right and left, have the same marks as the brush.
   
   

5. Attach the right end of the brush in the socket with the matching marking in the brush compartment
   
   

   
   
   
   

6. Push the brush in on the right, and attach the left end of the brush in the socket with the matching marking

   - Turn the brush, and check that both ends of the brush are securely attached in the sockets.

   

   
   
   
   

7. Hold the lift handle with one hand, and hold the handle down with another hand.

   - Please operate with two people.
   
   
   
   
   

8. Holding the lift handles by each set of hands, gently raise the machine using two people.

   - Please be cautious so the handle does not stick out of the machine.